How to solve the problem of forming charcoal machine rods?

The charcoal machinery and equipment produced by Jinhe Machinery is in line with China's energy-saving and environmental protection policy, and has been strongly supported by the vast number of users. It is important to bring many economic benefits to people. However, in order to ensure that charcoal machinery and equipment bring better and more economic benefits, it is necessary to produce high-quality charcoal. So how to solve the forming problem of charcoal machine bar machine?

In the actual production process, the rod making machine of charcoal machine equipment may encounter the situation that the salary bar can not be formed. When this happens, it is necessary to check whether the screw propeller of rod making machine is worn. If it is confirmed that the screw propeller is worn, it must be repaired or repaired. The repair method is as follows: the end of the screw propeller needs welding and preheating. When the temperature reaches about 200 C, wear-resistant electrodes are selected for surfacing, and the welding thickness exceeds the required thickness by 1-2 mm. Then, insert more than three guideways to cool, remove them when they are cooled below 50 degrees, and grind them on a silicon grinding wheel. Collision is strictly prohibited after maintenance of screw propeller. Attention should be paid to storage and storage for standby.

In the actual operation of charcoal machinery and equipment, customers should strictly follow the operating charter to avoid unnecessary problems.