Cause analysis of rod sticking problem of charcoal machine bar making machine

As the name suggests, charcoal machine is used to produce charcoal equipment. Charcoal produced by charcoal machine can replace the use of natural charcoal in industry and life. Charcoal machine in the actual production process will always be affected. These factors will affect the normal operation of the charcoal machine, such as the charcoal machine rod opportunity to stick or stick out of shape problems.

The reason why the charcoal machine does not stick is that the humidity of the raw materials is too high to meet the requirements of the use. The raw materials are heated, the heating temperature of the charcoal machine is low, the heating temperature is raised, the material is clamped in the spiral groove of the charcoal machine, the upper groove of the heating barrel of the charcoal machine equipment and the groove of the heating barrel are dislocated and re-installed, and the power supply voltage of the charcoal machine is low. Inspection, bracket casing wear better, screw propeller wear repair; and charcoal machine rod out of shape is not because the moisture of charcoal machine raw materials is too high, to heat to remove moisture, and then after drying to meet certain moisture requirements, to heat the charcoal machine propeller angle to less than 20 degrees, grinding propeller Electric even number, according to the installation location for inspection and installation, charcoal machine heating ring to check regularly to ensure relaxation. All of these are the reasons why the charcoal machine does not produce sticks and sticks.