Language: Chinese line English

Company new

What problems will the bar making machine encounter in the production process of charcoal machine?

In the production line of charcoal machine, rod making machine is a very important production equipment. In the rod making machine, if improper operation will lead to a variety of faults, resulting in unqualified production of firewood rods, or the rod making machine can not be produced, then what problems will happen to the opportunity of rod making in charcoal machine?

1.,firing. It may be due to the following reasons: improper temperature control, excessive raw material moisture, propeller wear, shaft tip misalignment, blocked exhaust holes, propeller head screw too large or too small, serious wear and tear sleeve. In case of this situation, we should control each other according to the above reasons and make corresponding adjustments after finding out the reasons.

2. stick making machine is not good. If the heating temperature is too high or too low, the wear of the forming sleeve is serious, the angle of the propeller is not consistent, and the water content of the raw material is too large. The rod should be black-brown, uniform hardness, smooth surface, crack-free, smooth surface of the central hole and smooth exhaust.

3. bright face. There is bright light on the section of the bar, but the density is good but the hardness is not good. This is the reason why the head spiral is too steep at the beginning. It should be smoothed out.

4. surface cracks. The transverse crack is easy to occur on the rod when the moisture content of raw material is too large, but the longitudinal crack is often caused when the moisture content is too small. In addition, excessive heating temperature causes excessive softening of raw materials, resulting in insufficient supply. The general solution to the problem is to increase the diameter of the screw properly, or to grind the wall of the screw and increase the distance between the screw.

5. The center of the rod is small in density or contains scattered sawdust. This is because of the wear and tear of the root diameter of the propeller axle tip. It needs to be repaired and welded and thickened. The incorrect axle tip can also cause the above problems, which need to be corrected at high temperature.

6. anti gas. In production, the gas is ejected from the outlet, mainly due to insufficient feeding, and possibly due to excessive moisture content of raw materials, insufficient heating temperature and so on.

The bending of 7. rods. Raw water is too large.

8. "stuffy car". Raw materials mixed with larger particles and hard impurities, low voltage or heating temperature on the low side, or raw materials may not do, the former need to stop disassembly, remove impurities. The latter should continue to warm and soften raw materials or to dry again.

Carbon powder molding machine in the charcoal machine production line is 380V power and electricity, the body is mainly composed of steel materials with good conductivity. So need to install leakage protection switch in the power supply, install grounding device on the body; secondly, fire, molding rod is extruded in high temperature molding, usually out of the center hole with Mars, need to put the Mars back after the code, the day of production of the molding rod can be better directly coded into the kiln, do not pile up in the room It is very easy to cause fires.

Above is the charcoal machine production rod machine production faults and security risks, users to find reasons to solve, so as to run safer production, at the same time, users in the production of rod machine equipment maintenance, to avoid equipment failures and security risks, resulting in unnecessary losses.

CATEGORIES

CONTACT US

Contact: manager Zhang

Phone: 13203711666

Tel: 0371-69595878

fax: 0371-64311999

Q Q:ѯ

Email: 980300260@qq.com

Add: Gongyi city, henan province,waigou industrial zone

Scan the qr codeClose
the qr code